Puddle Lights

Overview

Wing-mounted ground (puddle) lights illuminate the ground area around the aircraft during boarding. Installed in the wing during construction.
AMP CPC Series 1 multi-pin connectors at the wing root allow the wings to be disconnected cleanly from the fuselage wiring harness. Simplifies trailering and storage.
Adhesive cable anchors bonded to the main spar for wire routing and bundling. Eliminates the need to drill holes in the spar for wire guides.

Use Deutsch DTM connectors for the light wiring.
Route wiring through the wing and connect at the wing root during Section 30 or 31, before the wing is skinned.
Install connectors and route wiring before the wing root area is closed (Section 30 or 31).
Route all wing wiring through the connector; label each pin during installation.
Bond to the spar before the leading edge skins are installed (Section 29 or 30).
Follow ClickBond surface preparation instructions for best adhesion.